Flywheel Clutch Face Machining

Inspect flywheel clutch mating surface. Machine friction surface of flywheel if it is scored or worn. If it is necessary to remove more than 1.524mm (0.060 inch) of stock from original thickness, or if flywheel thickness is less than 35.8mm (1.41 inch) after refacing, replace secondary flywheel. If necessary, refer to Flywheel, Dual Mass in the Removal and Installation portion of this section.

 CAUTION: Installation of a secondary flywheel less than 35.8mm (1.41 inch) thick can cause primary flywheel damage.