SECTION 303-01B: Engine — 3.0L (4V) | 2002 Escape Workshop Manual |
IN-VEHICLE REPAIR | Procedure revision date: 10/21/2002 |
Water Pump Pulley Remover/Replacer 303-S455 (T94P-6312-AH) | |
Crankshaft Damper Remover 303-009 (T58P-6316-D) | |
Seal Remover 303-409 (T92C-6700-CH) | |
Camshaft Seal Replacer 303-464 (T94P-6256-BH) | |
Camshaft Seal Protector 303-463 (T94P-6256-AH) | |
Pump Pulley Replacer 211-185 (T91P-3A733-A) |
Removal
NOTE: In order to make sure of correct sealing do not scratch the camshaft.
Using the special tools, remove the camshaft oil seal.CAUTION: Cylinder head camshaft journal caps and cylinder heads are numbered to verify that they are assembled in their original positions.
Loosen the LH camshaft cap bolts in sequence to allow the camshafts to rise from the cylinder head and remove the caps.Installation
NOTE: Be sure camshaft bearing caps are installed in the original positions.
Lubricate camshafts with Super Premium SAE 5W-20 Motor Oil XO-5W20-QSP or equivalent meeting Ford specification WSS-M2C153-H and carefully position the camshafts into the cylinder head.CAUTION: Do not install the camshaft journal thrust caps until all of the camshaft bearing caps have been installed, or damage to the thrust caps can occur.
Lubricate the bearing surfaces of the camshaft bearing caps with Super Premium SAE 5W-20 Motor Oil XO-5W20-QSP or equivalent meeting Ford specifications WSS-M2C153-H. Install the bearing caps and loosely install the bolts.NOTE: Lubricate the camshaft oil seal with Super Premium SAE 5W-20 Motor Oil XO-5W20-QSP or equivalent, meeting Ford specification WSS-M2C153-H.
Using special tools, install a new camshaft oil seal.