Section 12-03A: Air Conditioning System, Manual A/C-Heater
1996 F-150, F-250, F-350, F-Super Duty and Bronco, F-Super Duty Motorhome Chassis Workshop Manual
REMOVAL AND INSTALLATION

Heater Blower Motor and Blower Motor Wheel Assembly

Removal

  1. Disconnect electrical hardshell connector.

  1. Disconnect blower motor housing tube (19A786) from blower motor (18527).

  1. Remove four attaching screws and remove blower motor from A/C blower housing (19930).

  1. Remove pushnut from shaft and remove blower motor wheel (18504) from shaft.

Installation

  1. NOTE: The pushnut from shaft is included with a new blower motor wheel, but not with blower motor.

    Position blower motor wheel on shaft. Then, install a new pushnut on shaft.

  1. Install a new mounting seal on flange.

  1. Position blower motor in A/C blower housing and install four attaching screws.

  1. Cement blower motor housing tube on nipple of A/C blower housing with Liquid Butyl Sealer C9AZ-19554-B or equivalent.

  1. Connect electrical hardshell connector.

  1. Check blower motor for proper operation.