Wiper Control Switch

The wiper control switch is located in the end of the turn signal lever. To operate the windshield wiper, the ignition switch lock cylinder (11582) must be in the RUN position. In addition to OFF there are two fixed positions, LO (low), HI (high), and an interval position. The positions are selected by rotating the knob actuator. If the interval position is selected, the time between wiper cycles will decrease as the knob is rotated away from OFF, and will increase as the knob is rotated toward OFF. The wiper speed for interval wiper operation is fixed at LO (low) speed setting.

Intermittent

The intermittent wiper control switch, located in the knob at the end of the turn signal lever, operates as follows:

• The key must be in the RUN position to operate wiper.
• In addition to OFF, there are two fixed wiper speed positions, LO and HI, as well as an interval position.
• Positions are selected by rotating the knob actuator relative to the turn signal lever.
• If interval position is selected, the time between wiper cycles will decrease as the knob is rotated away from OFF and increase as the knob is rotated toward OFF.
• The time interval between wipes will vary depending on the knob's position from OFF.
• Wiper speed for interval wiper operation is fixed at the LO speed setting.