Section 11-03: Steering Linkage
1996 F-150, F-250, F-350, Bronco and F-Super Duty Workshop Manual
REMOVAL AND INSTALLATION

Drag Link, Steering Sector Shaft Arm, F-Super Duty Motorhome Chassis

SPECIAL SERVICE TOOL(S) REQUIRED
DescriptionTool Number
Pitman Arm PullerT64P-3590-F

Removal

  1. Remove the cotter pins and nuts from the drag link ball studs.

  1. Using Pitman Arm Puller T64P-3590-F remove the drag link ball studs from the steering gear sector shaft arm (3590) and steering arm.

Installation

  1. Install the ball studs into steering gear sector shaft arm and steering arm.

  1. Install the ball stud nuts. Tighten to 75-105 Nm (55-77 lb-ft). Install new cotter pins through the nuts and ball studs.