Section 10-03: Speed Control System, Electronic
1996 F-150, F-250, F-350, F-Super Duty and Bronco Workshop Manual
ADJUSTMENTS

Actuator Cable

 

  1. Remove cable retaining clip from actuator cable at accelerator cable bracket (9723).

  1. Set throttle plate to closed position.

  1. Pull on the actuator cable to take up any slack. Back off at least one notch so that there is 1mm (0.040 inch) of slack in the cable. The cable must not be pulled tight for proper operation.

  1. While holding the cable, insert the retaining clip and snap securely.