Section 10-02: Accelerator Pedal and Linkage
1996 F-150, F-250, F-350, F-Super Duty and Bronco Workshop Manual
REMOVAL AND INSTALLATION

Accelerator Pedal and Shaft

Removal

  1. Remove accelerator cable (9A758) from accelerator pedal and shaft (9725).

  1. Remove the screws holding the accelerator pedal and shaft to the instrument panel (04320).

  1. Remove the accelerator pedal and shaft from the instrument panel.

Installation

  1. NOTE: For F-Super Duty Motorhome Chassis vehicles, position accelerator pedal and shaft to instrument panel and install retaining screws.

    For F-Series and Bronco, position accelerator pedal and shaft to instrument panel and install lower screw hand-tight.

  1. Install upper screw and tighten to 21-29 Nm (16-21 lb-ft).

  1. Install middle screw and tighten to 21-29 Nm (16-21 lb-ft).

  1. Tighten lower screw to 21-29 Nm (16-21 lb-ft).

  1. Snap accelerator cable into slotted hole in accelerator pedal and shaft.