Section 06-09B: Brake, Anti-Lock, 4-Wheel
1996 Bronco Workshop Manual
REMOVAL AND INSTALLATION

Brake Sensors, Front

Removal

  1. From inside engine compartment, disconnect front brake anti-lock sensor two-pin connector from wiring harness.

  1. Separate front brake anti-lock sensor cable from brake hose clips.

  1. Remove front brake anti-lock sensor retaining bolt from front spindle and slide front brake anti-lock sensor (2C204) out of mating hole.

Installation

For installation, follow removal procedures in reverse order. Tighten retaining bolt to 5-6 Nm (44-53 lb-in).