Section 06-09B: Brake, Anti-Lock, 4-Wheel
1996 Bronco Workshop Manual
REMOVAL AND INSTALLATION

Control Module, Anti-Lock Electronic

Removal

  1. Disconnect battery positive cable.

  1. Locate anti-lock brake electronic control module at left front fender apron. Disconnect 40-pin connector from anti-lock brake electronic control module.

  1. Remove screws retaining anti-lock brake electronic control module to mounting bracket.

  1. Gently slide anti-lock brake electronic control module along bracket and remove anti-lock brake electronic control module.

Installation

  1. Insert rivet into large hole portion of teardrop. Gently slide anti-lock brake electronic control module along bracket to engage rivet.

  1. Install retaining screw and tighten to 7-9 Nm (62-80 lb-in).

  1. Connect 40-pin connector and tighten bolt to 6-7 Nm (53-62 lb-in).

  1. NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module (PCM) (12A650) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

    Connect battery positive cable.