Install the front wheel spindle and left shaft assembly. Refer to Spindle, RH and LH Shaft and Joint Assembly in the Removal and Installation portion of this section.
Section 05-03A: Axle, Front Drive, Dana Models 44 and 50 | 1996 F-150, F-250 4x4 and Bronco Workshop Manual |
| Description | Tool Number |
|---|---|
| Puller | T58-101-B |
| Differential Axle Seal Replacer | T80T-4000-H |
Removal
Remove the front wheel spindle (3105) and left shaft assembly as described in this section.
Pull out the seal with Puller T58L-101-B. Remove and discard seal.
Installation
Lightly coat a new seal with High Temperature 4x4 Front Axle and Wheel Bearing Grease E8TZ-19590-A or equivalent meeting Ford specification ESA-M1C198-A.
Install seal on the Differential Axle Seal Replacer T80T-4000-H.
Slide the seal and tool into the carrier housing bore. Seat the seal with a nylon or rawhide hammer.
Install the front wheel spindle and left shaft assembly. Refer to Spindle, RH and LH Shaft and Joint Assembly in the Removal and Installation portion of this section.