Sensor, Anti-Lock Brake

Removal

1. Disconnect electrical connector and remove rear anti-lock sensor hold-down bolt. Remove rear brake anti-lock sensor (2C190).

2. Clean axle mounting surface, using caution to prevent dirt from entering rear axle housing (4010).

Installation

1. If new rear brake anti-lock sensor is to be installed, lightly lubricate O-ring with motor oil.

   1. Firmly grasp rear brake anti-lock sensor at sides (do not install by applying force on connector) and push into axle housing, aligning mounting flange hole with threaded hole in rear axle housing.
   2. Install hold-down bolt and tighten to 34-40 Nm (25-30 lb-ft).

2. If old rear brake anti-lock sensor is to be reinstalled, clean and blow off metal particles using compressed air.

   1. Remove and replace O-ring with a new O-ring.
   2. Apply a light film of motor oil to O-ring.
   3. Firmly grasp rear brake anti-lock sensor at sides (do not install by applying force on connector) and push into axle housing, aligning mounting flange hole with threaded hole in rear axle housing.
   4. Install hold-down bolt and tighten to 34-40 Nm (25-30 lb-ft).
      
      
      
      
      

      Item	Part Number	Description
      1	390356	Hold-Down Bolt
      2	2C190	Rear Brake Anti-Lock Sensor
      3	—	Connector Seal (Part of 2C190)
      4	NBR017	O-Ring
      A	—	Tighten to 34-40 Nm (25-30 Lb-Ft)