Section 04-02: Suspension, Rear
1996 F-Series and Bronco Workshop Manual
REMOVAL AND INSTALLATION

Wheel Hub Bolt, Rear

SPECIAL SERVICE TOOL(S) REQUIRED
DescriptionTool Number
C-Frame and Clamp Assembly ToolT74P-3044-A1

 CAUTION: Never use a hammer to remove the wheel hub bolt nut. Damage to the axle shaft flange or rear wheel bearing may result.

 

Removal

  1. Raise the vehicle and install safety stands.

  1. Remove the wheel and tire assembly. Refer to Section 04-04.

  1. Remove the brake drum (1126) from the studs.





  1. Using C-Frame and Clamp Assembly Tool T74P-3044-A1, press the lug bolt (1107) from its seat in the axle flange. The lug bolt may also be removed by pressing it out using an appropriate sized socket and C-clamp. Discard the lug bolt.





 

Installation

  1. Insert new lug bolt in hole in flange. Rotate lug bolt slowly. Make sure serrations are aligned with those made by the original bolt.

  1. Place four flatwashers over the outside end of the stud and thread the lug nut (1012) with the flat side against the washers.

  1.  CAUTION: DO NOT use air tools. The serrations may be stripped from the stud.

    Tighten the lug nut until the bolt head seats against the back side of the flange.

  1. Remove lug nut and washers.

  1. Install brake drum and wheel (1007).

  1. Lower the vehicle.