Section 03-14: Engine Controls, Electronic
1996 F-150, F-250, F-350, F-Super Duty Series and Bronco Vehicles Workshop Manual
REMOVAL AND INSTALLATION

Injection Control Pressure Regulator

Diesel Engine

Removal

  1. Remove fuel filter/fuel heater/water separator assembly. Refer to Section 10-01B.

  1. Disconnect injection control pressure regulator electrical connector.

  1. Remove solenoid retaining nut and remove solenoid.

  1. Remove injection control pressure regulator.





Installation

  1. Install injection control pressure regulator. Tighten to 47 Nm (35 lb-ft).

  1. Install solenoid and solenoid retaining nut. Tighten to 6 Nm (53 lb-in).

  1. Connect regulator electrical connector.

  1. Install fuel filter/fuel heater/water separator assembly.