Section 03-14: Engine Controls, Electronic
1996 F-150, F-250, F-350, F-Super Duty Series and Bronco Vehicles Workshop Manual
REMOVAL AND INSTALLATION

Engine Oil Temperature (EOT) Sensor

Diesel Engine

Removal

  1. Disconnect engine oil temperature sensor electrical connector.

  1. NOTE: Approximately 0.94 liters (one quart) of engine oil must be removed prior to sensor removal.

    Remove one quart of engine oil from high pressure oil pump reservoir using Rotunda Vacuum Tester 014-R1058 or equivalent.

  1. Remove engine oil temperature sensor.





Installation

  1. Install engine oil temperature sensor.

  1. Connect engine oil temperature sensor electrical connector.

  1. Fill engine oil to proper level.

  1. Refill oil pump reservoir with engine oil.