Section 03-01A: Engine, 4.9L SFI
1996 F-150, F-250, F-350 (4x2), F-150, F-250 (4x4) Workshop Manual
IN-VEHICLE SERVICE

Oil Pump

 

Removal

  1. Remove the oil pan (6675).

  1. Remove oil pump (6600). Remove oil pump screen cover and tube (6622).

Installation

  1. Prime the oil pump by filling the inlet opening with oil and rotating the oil pump intermediate shaft (6A618) until oil emerges from the outlet opening.

  1. Assemble oil pump inlet tube gasket (6626), oil pump screen cover and tube to oil pump. Tighten screws to 16-24 Nm (12-18 lb-ft).

  1. Install oil pump and tighten screw to 16-24 Nm (12-18 lb-ft) and nut to 30-43 Nm (22-32 lb-ft).

  1. Install oil pan.

    ItemPart NumberDescription
    1391378Screw, 5/16-18 x 1.13
    233711Nut
    36622Oil Pump Screen Cover and Tube
    4391378Screw, 5/16-18 x 1.13
    56626Oil Pump Inlet Tube Gasket
    6—Dowel (Part of 6600)
    7—Number 5 Main Bearing Cap Stud (Part of 6010)
    86600Oil Pump
    A—Tighten to 16-24 Nm
    (12-18 Lb-Ft)
    B—Tighten 30-43 Nm
    (22-32 Lb-Ft)