Safety Belt Procedure After a Collision

 WARNING: ALL SAFETY BELT ASSEMBLIES INCLUDING RETRACTORS, BUCKLES, FRONT SEAT BELT BUCKLE SUPPORT ASSEMBLIES (SLIDE BAR), IF SO EQUIPPED, CHILD SAFETY SEAT TETHER ATTACHMENTS, (IF SO EQUIPPED), AND ATTACHING HARDWARE SHOULD BE INSPECTED AFTER ANY COLLISION. ALL BELT ASSEMBLIES SHOULD BE REPLACED UNLESS A QUALIFIED TECHNICIAN FINDS THAT THE BELTS SHOW NO DAMAGE AND OPERATE PROPERLY. BELT ASSEMBLIES NOT IN USE DURING A COLLISION SHOULD ALSO BE INSPECTED AND REPLACED IF EITHER DAMAGE OR IMPROPER OPERATION IS NOTED.

Safety belt assemblies should be periodically inspected to make sure they have not become damaged and are in proper operating condition, particularly if subjected to severe stress.

Before installing the new safety belt assembly, the safety belt attaching areas must be inspected for damage and distortion. If the attaching points are damaged and distorted, the sheet metal must be worked back to its original shape and structural integrity.

Install the new safety belt(s) using the appropriate instructions. Perform Functional Test Procedure in Service Procedures in this section.