Section 01-14B: Door Lock Control System, Electronic
1996 F-150, F-250, F-350 and Bronco Workshop Manual
REMOVAL AND INSTALLATION

Antenna

Removal

This vehicle uses a PIA-type antenna. DO NOT remove existing antenna from wire harness. The antenna is taped to the wire harness connected to the remote entry module.

  1. Disconnect antenna connector from remote entry receiver module and tape securely out of the way.

 

Installation

  1. Connect new antenna connector to remote entry receiver module.

  1. Install new PIA-type antenna into vehicle, taping along wire harness path followed by old (unconnected) PIA antenna. Secure using approved tie-wrap or tape.