Section 01-14A: Handles, Locks, Latches and Mechanisms
1996 F-150, F-250, F-350, F-Super Duty and Bronco Workshop Manual
REMOVAL AND INSTALLATION

Lock Cylinder, Door

NOTE: When a door lock cylinder (21985) is replaced, both door lock cylinders should be replaced in a set. This will eliminate carrying an extra key which will fit only one lock. If a key is to be replaced, the new key code number is stamped on a metal tag attached to the key.

Removal

  1. Roll the window up.

  1. Remove access hole cover and/or front door trim panel (23942) and pull away watershield, if equipped. Refer to Section 01-05.

  1. Disconnect the front door latch actuating rod (22152) from the lock door latch operating lever.

  1. Slide the lock cylinder retainer away from the door lock cylinder.

  1. Remove the door lock cylinder.

Installation

  1. Follow removal procedures in reverse order.