Crankshaft Pulley

Special Tool(s)

	Strap Wrench 303-D055 (D85L-6000-A), or equivalent
	Remover, Crankshaft Vibration Damper 303-009 (T58P-6316-D)
	Installer, Crankshaft Vibration Damper 303-102 (T74P-6316-B)

Material

Item	Specification
SAE 5W-20 Premium Synthetic Blend Motor Oil XO-5W20-QSP	WSS-M2C153-H
Silicone Gasket and Sealant F7AZ-19554-EA	WSE-M4G323-A4
Metal Surface Cleaner F4AZ-19A536-RA	WSE-M5B392-A

Removal and Installation

1. Remove the accessory drive belt. For additional information, refer to Section 303-05.

2. Remove the splash shield.

3. Install the special tool.

4. Remove the crankshaft pulley bolt and washer.

5. Using the special tool, remove the crankshaft pulley.

Installation

1. NOTE: Clean the keyway and slot using metal surface cleaner before applying silicone gasket and sealer.

   NOTE: Seal surfaces must be free of dirt and oil.

   NOTE: The crankshaft pulley must be installed within four minutes of applying the silicone gasket and sealer.

   Apply silicone gasket and sealant to the end of the keyway slot.

2. NOTE: Lubricate the outside diameter sealing surface of the crankshaft pulley with clean engine oil.

   Using the special tool, install the crankshaft pulley.

3. NOTE: Use an appropriate strap wrench to hold the crankshaft pulley.

   Install the bolt and the washer and tighten in four stages.
   • Stage 1: Tighten to 120 Nm (86 lb-ft).
   • Stage 2: Loosen 360 degrees.
   • Stage 3: Tighten to 50 Nm (37 lb-ft).
   • Stage 4: Tighten an additional 90 degrees.

4. Install RH front inner splash shield.

5. Install the accessory drive belt. For additional information, refer to Section 303-05.