Section 03-14: Engine Controls, Electronic
1996 F-150, F-250, F-350, F-Super Duty Series and Bronco Vehicles Workshop Manual
REMOVAL AND INSTALLATION

Powertrain Control Module (PCM)

Gasoline and Diesel Engines

Removal

  1. NOTE: Refer to EVTM for location of PCM in specific vehicle.

    Disconnect battery negative cable.

  1. Loosen engine control sensor wiring (12A581) to PCM connector retainer bolt.

  1. Remove engine control sensor wiring connector from powertrain control module (PCM) (12A650).

  1. Remove the two PCM seal nuts and loosen left fender liner screws and remove liner or bend down to clear powertrain control module. Remove powertrain control module.

Installation

  1. Follow removal procedures in reverse order.

  1. Tighten PCM retainer screw to 3-4 Nm (27-35 lb-in). Tighten engine control sensor wiring connector retainer bolt to 4 Nm (35 lb-in).